Armiruem Brakes
So Armiruem! Buck, lining and other details that are close to the repaired parts, cover with polyethylene. If still get spray brake fluid on painted parts, immediately wipe off with a cloth. Remove the cover reservoir with brake fluid and flick it with a syringe. Begin dismantling the hose from the lower mount, in time, substitute for support to the bank – less spill on the floor tormozuhi. Braided hoses are sold already assembled or in the form of recruitment of a piece of hose (when buying you need to know its length) and two complexes, most of which will collect tips. Ready to install easier, but still need to find the appropriate size, and cost will be expensive. And if that – Then the bike redone – no kit is necessary.
Sam Hose take longer, with the stock – too much cut off, but the increase can not be short. First, lay the hose from the caliper to the master brake cylinder and check length. Do not forget that each of the lugs on a couple of inches lengthen the hose. At maximum during the wheel he should not stretch! But hang loops it is bad – you can catch on that – anything. Assembly tips convenient to carry in a small vise, firmly attached to the table. Hold them in connection tip, wrapping it with several layers of paper or carton to prevent damage to the bearing surfaces. Put the nut on the hose. Gently fan the braided hose and put the sleeve on his inner tube so that it was under the braid.